How To Connect PS3 on the Internet

Google+ Pinterest LinkedIn Tumblr +

1. Connection “By Wire” for users who use dialers to connect to the Internet.

1.1 – Ip
1.2 – Subnet Mask
1.3 – Standard Router
1.4 – Primary DNS
1.5 – Secondary DNS

2. Connection “Wireless” for those with Kyocera’s trademark “Buffalo” WI-FI AirStation with the option “AOSS”.
This configuration using a router “Buffalo – WHR-G54S / U”.
____________________________________________________

Starting the configuration of connection “By Wire”.

1 – Go to “Settings”, then “Network Settings”.

01ym3.jpg

1.2 – Internet Connection Settings

02iv8.jpg

1.3 – Method of connection “Connection by wire”

03sd3.jpg

1.4 – Custom

04dw6.jpg

1.5 – Automatic detection

05cv2.jpg

1.6 – Manual

06ie6.jpg

1.7 – Here we make the configuration of PC – Subnet Mask – Router Standard – Primary DNS and Secondary DNS.

To put the IP if you do not know, just click: Start – Run and type CMD and the command will display the screen of the DOS Prompt, type ipconfig it, will soon show:
IP Address
Subnet Mask
Default Gateway, the same as Default Router that is written in the PS3.
The first is that IP is the IP informing that the PC is using, when it was configured, so let’s just change the last number:
Ex: PC’s IP 192.168.11.10 change only the last number in the PS3 thus putting 192.168.11.11
Subnet Mask will use the same standard as it is showing you 255.255.255.0
Default Gateway is the IP from your “router”, “modem” that will put you in the Default Router PS3.

To configure DNS primary and secondary DNS, just call and ask for phone numbers, for those who are in your country.
Example of how the configuration will be to continue the setup

IP 192.168.11.11
Subnet Mask 255.255.255.0
Default router – the IP router
Primary DNS —
Secondary DNS —

07vn6.jpg

1.8 – MTU “Automatic”

08ci8.jpg

1.9 – Proxy Server “No Use”

09fu9.jpg

1.10 – UPnP “Enable”

10qx3.jpg

1.11 – Confirm the installation and test the connection

11ow8.jpg

12jy8.jpg

__________________________________________________________________________

Starting the configuration of connection “Wireless”

2. Follow steps 1 and above 1.2

2.1 – Method of connection “wireless”

01ni6.jpg

2.2 – WLAN Settings “Automatic”

02et3.jpg

2.3 – Select the option “AOSS”

03ur5.jpg

2.4 – Just push the button at the top of the router as it is in the picture and wait for the PS3 could receive the settings that are fully automatic.

http://img160.imageshack.us/img160/7892 … 54seg0.jpg

04cp3.jpg

2.5 – There is no need to use the advanced settings just put on “No” and move

05aw4.jpg

2.5 Just save the setting and then test so you can verify the certification.

06ep9.jpg

07mj2.jpg

08fx5.jpg

Share.

About Author

Leave A Reply